FBIC - Ball Valve,Gate Valve,Check Valve,Globe Valve & Butterfly Valve Manufacturer & Supplier
Ball Valve
- Floating Ball Valve
- Trunnion Ball Valve
- Top Entry Ball Valve
- Full Welded Ball Valve
- DBB Valve
- Thread End Ball Valve
Gate Valve
- PConduit Gate Valve
- Wedge Gate Valve
Globe Valve
- Straight Way Globe Valve
- Angle Globe Valve
- Bellow Seal Globe Valve
Check Valve
- Swing Check Valve
- Wafer Check Valve
Plug Valve
- Sleeve Plug Valve
- Lubricated Plug Valve
- Orbit Plug Valve
Butterfly Valve
- Metal to Metal Butterfly Valve
- Soft Seal Butterfly Valve
Compact Forged Steel Valve
Other

 
 
Date:2010-01-07 Author: www.fsbic.com

Trunnion ball valve is the new generation of high-performance ball valve,applicable to long-distance pipelines and general industrial pipelines,it take special consider about it's strength ,safty and resistant to bad environment when in designing,applicable to various corrosive and the non-corrosive medium.It compared with floating ball valve ,,when working ,Before the valve in the sphere fluid pressure produced all the forces to bearing,can't make the ball move toward seat ,so the seat will not bear overlarge pressure ,So the trunnion ball valve have small torque,Seat distortion small,Sealing performance is stable,Long service life,applicable to high voltage, large diameter.Advanced spring and seat module,have tight seal, realize upstream sealing.Each valve has two seats,ach direction can be sealed,Therefore, install havn't flow direction limitation,is two-way.This valve is usually horizontal installed.
Five feature of trunnion ball valve

1.Operation save effort:ball support by fluctuation bearing ,reduce the friction,Eliminate the inlet pressure due to push the spheroid and seal seat sealing load of the torque caused by excessive.
2.Sealing is reliable:PTFE unisexual sealing materials embedded in stainless steel seat, The metal valve seat end with spring ensure sealing enough pre-tightening force, sealing wear when the valve is in using , the valve to ensure good sealing under the spring action .
3.Fire structure:To prevent fire or the heat appear,Make PTFE seals burned,happen large leakage,so help the fire,set the safe sealing ring between ball and seat ,when the sealing ring burning ,ueder the action of spring ,make the seaing ring push to ball quickly, forming metal to metal seal,Have certain degree of sealing effect.refractory testing accord with APl6FA and APl607 standard .
4.Automatic relief function:When the stagnation medium pressure in valve lumen anomalies higher than the pre-tightening force of spring ,Seat back from the ball,achieve automatic relief effect,seat automatic reset after pressure relife.
.5.Drain pipe:it is all set drainboles up and down of body, It can check seat whether occurs leakage,when in working ,valve in full open or full close,relife the lumen pressure,can replace the packing directly£»can discharge the lumen's stickers,reduce the medium make pollution to valve.




All rights reserved by FBIC Inc., do remember to show the source (www.fsbic.com) of the news when copying.



 

 

 
 
                     
 
America Division Tel:001-917-582-1828 Fax:001-212-684 2352 e-mail: sales@fsbic.com
Copyright(C) 2003-2010 FBIC,Inc.  All Rights Reserved.